- Lab
- Dentistry
- Applicators & Prophy
- Bite Registration Materials
- Blood Sugar / Pressure Test
- Dental Accessories
- Dental Dam
- Dental Instruments
- Dentistry Bur
- Handpiece Oil
- Impression Materials
- Impression Remover / Gutta Percha Solvent
- Impression Tray
- Matrix Systems
- Mixing Tip / Mixing Pax / Dispenser Gun
- Oral Acid / Oral Care
- Oral Hygiene
- Periodontic
- Polishing
- Preventive
- Preventive, Oral Hygiene, Haemostasis
- Prosthodontic
- Relining Materials
- Restorative
- Root Canal Treatment / Endo
- Scaler Tip / Endo Tip / Perio Tip / Wrench
- X-Ray Film & Accessories
- Disinfectant
- Disposable
- Autoclave Tape
- Clinical Waste Container / Medication Envelope / Plastic Container
- Dental Accessories
- Dental Evacution / Suction Tip / Cup
- Disposable Cap / Apron / Gown / Shoes & Boots Cover
- Disposable Needle
- Disposable Syringe
- Examination Set / Fluoride Tray
- Eye, Face & Hand Protection
- Gauze / Non-Woven / Cotton
- Gloves
- Mixing Tip / Mixing Pad / Mixing Well / Dapper / Spatula
- Plastic Sleeves
- Sterilization Crepe Paper
- Sterilization Flat Reels
- Sterilization Paper Bag
- Sterilization Pouches
- Tissue / Hand Towel / Dental Bib / Barrier Film
- Orthodontic
- Dentistry Material
- Others
MJ Dental Supplies
47G & 49G, Jalan Pahat J15/J, Kompleks Otomobil, Seks. 15, 40200 Shah Alam, Selangor, Malaysia.
+603-5545 8299
+6012-292 8299
+6012-292 8299
+603-5523 8299
PACOBATH ACRYDIG 6 - POLYMERIZING UNIT MANFREDI, ITALY
| Previous | 4 / 45 | Next |
PACOBATH ACRYDIG 6 - POLYMERIZING UNIT
SPECIFICATIONS
BRAND:
- ACRYDIG polymerizing units are completely built in stainless steel to guarantee a long-lasting life. The special design of the closing lid avoids any dispersion of steam or condensate dripping, thus ensuring the polymerization cycle in a steam saturated atmosphere. The wide opening and the adequate dimensions of the polymerization tank allow a rational accommodation of the flasks. The electronic board controls one-step or two-step polymerization cycles, a pre-start setting, the automatic switch off at the end of the cycle and constantly shows the cycle progress. These parameters allow a controlled polymerization process with natural cooling, thus avoiding any micro-fracture of the resin, usually caused by a sudden cooling. Acrydig is also equipped with water tap on the side, to quickly drain the polymerization chamber. The heating cycle safety is ensured by a sensor, constantly checking the presence of water inside the chamber; in case the level is too low, the system automatically interrupts the heating.
SPECIFICATIONS
- Power (w) : 1100
- Chamber width (cm) : 15
- Chamber depth (cm) : 31
- Chamber useful height (cm) : 26
- Capacity : 6-10 flasks
- External width (cm) : 19
- External depth (cm) : 42
- External height (cm) : 38
- Net/gross weight (kg) : 8/9
BRAND:
- MANFREDI (MADE IN ITALY)